www.lancermods.com
  • Home
  • Basics
    • History of Lancer
    • Mitsubishi Lancer Evolution
    • Terms to Know
    • Cheap Lancer Mod Parts
    • Bolt-On Mods Lancer Parts
  • Performance
    • Increase Horsepower
    • Short Ram Intake vs Cold Air Intake >
      • SRI Install
    • Catback vs Axleback Exhaust
    • Turbo Basics
    • Turbo Set-Up
    • Nitrous Oxide
  • Suspension
    • Front Strut Bar
  • Interior
    • Lights
  • Exterior
    • Window Tint
    • How To: Paint Brake Calipers
    • How To: Plasti Dip Front End
    • How To: Debadge Car
  • Contact
Lancer Mods

How to debadge your lancer

How to debadge your lancer.

So first thing you need to gather are the following:
Hair Dryer
Soapy Water
Cloth to Wipe
Fishing Line
Some sort of Plastic Card

Now to begin debadging your car:
1. Wipe down your emblem of any dust/dirt
2. Take your hair dryer, and set it to your hot setting. Try to heat up the entire emblem for 2-5 minutes.
3. Take a string of the fishing line (should be fairly thin, to slide between your emblem and hood) and slide it between your emblem and hood. You should use a rocking motion (left and right) to slide it through. It will be a bit tough, especially down the middle, but just keep heating it up and rocking, it'll go through.
4. Next you'll take the plastic card, and basically you'll want to try to scrape off the excess residue. You can probably use Goo Gone for this, but you can also just scrape and heat. After you've scraped off most of it, you can use the cloth to wipe off any of the left over residue. You can also follow up with some wax etc.

And you're done. Happy debadging!
Powered by Create your own unique website with customizable templates.